Measurements
and Control LTD
Call Today 416-667-0918
Products

KRYPTON DAQ Modules

KRYPTON DAQ modules are engineered to withstand and operate flawlessly in cold places, hot places, dust, mud, water and snow. KRYPTONs are shock proof, vibration proof, milled out of full block of aluminium and filled with rubber making them fully water-proof. KRYPTON modules are IP67 rated (TH8/TH16 only), have -40°C to 85°C Operating Temperature range,

KRYPTON

Put it right in place

Small KRYPTON modules allow perfect placement near the source of your data. Connect with single cable for data, power and sync. Short sensor wires save cost and improve the signal quality. Data link allows up to 100 m distance from module to module. You can also stack them up in blocks using simple lock mechanism.

Perfect connectivity

KRYPTON modules are connected to your computer via industrial standard Ethernet connection (EtherCAT® protocol) which provides 100 Mbit data link for hundreds of channels with more than 10 kHz data rate per channel and perfect synchronisation between devices. KRYPTON modules are EtherCAT®Fully Compliant and Compatible with third party EtherCAT® masters, like Beckhoff – TwinCAT.

  • KRYPTON
  • KRYPTON
  • KRYPTON
  • KRYPTON

Ease of use

When KRYPTON modules are connected to computer via standard Ethernet connection devices are automatically detected without a need to set up any IP address configuration. Once connected simply enjoy full power of DEWESoft X Software which is included with every KRYPTON module.

KRYPTON

Tech specs

KRYPTONi 8xTH / KRYPTONi 16xTH

KRYPTON

Thermocouple inputs have universal input connector allowing usage of any thermocouple type. All the channels are isolated between each other and the ground. They run with 100 Hz sample rate per channel.

Analog inputs
Input channels8 (8xTH) or 16 (16xTH) isolated universal thermocouple and voltage
Input signalsTC types: K, J, T, R, S, N, E, C, U, B, Voltage: 1V and 100mV
Input connectorMini Thermocouple connector (copper)
Sampling rateMaximum 100 Hz per channel (software selectable)
ADC type24 bit sigma delta
Input impedance> 100 MΩ
Isolation voltage1000 V channel/ground & channel/channel
Resolution< 0.001 deg. C
AccuracyTC: ±0.02% of reading ±0.5 °C ±10μV, Voltage: ±0.02% of reading ±10μV
Gain drift over temperaturetyp. 3ppm/K (max. 10 ppm/K)
Offset drift over temperature0.03µV/K
Noise0.25μVrms (=0.007°Crms@Type K)@10 S/s
0.7μVrms (=0.02°Crms@Type K)@100 S/s
General specs
InterfaceLEMO 1B EtherCAT cable (single cable connection power + sync + data)
Data rate100 Mbit bus speed
Power supply voltage6 to 50 V DC
Power consumption3 Watt (8xTH), 4 Watt (16xTH)
Dimensions8xTH: 200x50x30 mm
16xTH: 200x50x45 mm
Weight8xTH: Typically 650 g
16xTH: Typically 900 g
Environmental ratingIP67
Shock & Vibration Rating> 100 g
Temperature range-40 .. 85 deg. C
Supported Software & Hardware PlatformsSoftware: DEWESoft X
Hardware: KRYPTON modules synchronize with all other DEWESoft Hardware

KRYPTONi 4xLV / KRYPTONi 8xLV

KRYPTONi 4xLV / KRYPTONi 8xLV

Low voltage input is 100 V isolated amplifier, running with sample rate that reaches up to 20 kHz per channel. All the channels are isolated between each other and the ground.

Analog inputs
Input channels4 (4xLV) or 8 (8xLV) isolated voltage
Input signals±100V
Input connectorBNC
Sampling rate20kS/s per channel (software selectable)
ADC type24 bit
Input impedance> 1 MΩ
Isolation voltage1000 V channel/ground & channel/channel
Resolution0.01 mV
Accuracy±0.03% ±5mV
Gain drift over temperaturetyp. 10ppm/K (max. 20 ppm)
Offset drift over temperature10µV/K
Noise0.7mVRMS
General specs
InterfaceLEMO 1T EtherCAT Hybrid cable (Power & Data in one cable)
Data rate100 MBit bus speed
Power supply voltage6 to 50 V DC
Power consumption2.5 Watt (4xLV), 3 Watt (8xLV)
Dimensions4xLV: 200x50x30 mm
8xLV: 200x50x45 mm
Weight4xLV: Typically 650 g
8xLV: Typically 900 g

Environmental ratingIP65
Shock & Vibration Rating> 100 g
Temperature range-40 .. 85 deg. C
Supported Software & Hardware PlatformsSoftware: DEWESoft X
Hardware: KRYPTON modules synchronise with all other DEWESoft Hardware

KRYPTON 3xSTG

KRYPTON-3xSTG

Universal STG 10V amplifier running with sample rate that reaches up to 20 kHz per channel. Inputs are compatible with DSI adapters which can additionally support IEPE/ICP sensors, LVDTs, charge, thermocouple and more.

Analog inputs
Input channels3 differential voltage or strain
Input signalsVoltage: 10V, 1V, 100mV or 10 mV
Strain: 2 .. 1000mV/V programmable, Full, Half, Quarter 120/350Ω 3 wire
Excitation: 1 .. 15V programmable, max. 0.4 W/ch.
ADC type24 bit
Sampling rateMax 20 kHz per channel (software selectable)
Isolation voltageDifferential input
Input couplingDC
Input impedance10 MΩ
Accuracy±0.03% of reading ±0.02% of range ±0.1mV
Gain drift over temperaturetyp. 10ppm/K (max. 40 ppm/K)
Offset drift over temperaturetypical 0.3 μV/K + 5 ppm of range/K
Noiseup to 100 dB
Programmable Shunt (default Values)100k Ohm
IEPE/ICP SensorsDSI adapter
ResistanceDSI adapter
Temp. (PT100 to PT2000)DSI adapter
Temp. (Thermocouple)DSI adapter
PotentiometerYES
LVDTDSI adapter
ChargeDSI adapter
CurrentExternal Shunt
TEDS interfaceYES
Advanced functionsLow power, Sensor and Amplifier balance
Connector typeDB9, L1B10f
General specs
InterfaceLEMO 1T EtherCAT Hybrid cable (Power & Data in one cable)
Power supply voltage6 to 50 V DC
Power consumption2.4 W (4W 120R @ 5V load) ???
Dimensions202x54x38 mm
WeightTypically 650 g
Environmental ratingIP67
Shock & Vibration Rating> 100 g
Temperature range-40 .. 85 deg. C
Supported Software & Hardware PlatformsSoftware: DEWESoft X
Hardware: KRYPTON modules synchronise with all other DEWESoft Hardware

KRYPTON 8xRTD

KRYPTON-8xRTD

8 channel isolated universal PTx temperature (PT100, PT200, PT500, PT1000, PT2000 ), resistance and voltage analog input module with sampling rates up to 100 Hz per channel.

Analog inputs
Input channels8 channels
Isolated universal PTx temperature, resistance and voltage
Input signalsPT-types: PT100, PT200, PT500, PT1000 , PT2000
Resistance: 500 Ω and 10 kΩ
Voltage: 1V and 100 mV
Input connectorLEMO 0B 6-pin
Sampling rateMaximum 100 Hz per channel (software selectable)
ADC type24 bit sigma delta
Input impedance> 10 MΩ
Isolation voltage peak1000 V channel/ground & channel/channel
Resolution< 0.001°C
AccuracyTemperature: ±0.05°C
Voltage: ±0.02% of reading ±10µV
Gain drift over temperatureTyp. 3ppm/K (max. 10 ppm/K)
Offset drift over temperature0.03 µV/K
Noise0.25 µVrms @ 10 S/s
0.7 µVrms @ 100 S/s
Gain drift over temperatureTyp. 3ppm/K (max. 10 ppm/K)
General specs
InterfaceLEMO 1T EtherCAT® cable (single cable connection power + sync + data)
Data rate100 Mbit bus speed
Power supply voltage6 to 50 V DC
Power consumption3 Watt
Dimensions200x50x30 mm

KRYPTON 16xDI, KRYPTON 16xDO, KRYPTON 8xDI 8xDO,

KRYPTON 16xDI, KRYPTON 16xDO, KRYPTON 8xDI 8xDO

Digital input/output module. All Krypton DIO modules have 25 pin DSUB connectors that are available also in waterproof version. They have power supply of 5V and 12V to power the switches or sensors. Krypton DIO has no counter interface functionality. For this you need to choose appropriate SIRIUS instrument.

 Krypton 16xDIKrypton 8xDI 8xDOKrypton 16xDO
Digital inputs
Input channels (isolated)168-
CompatibilityCMOS Configuration-
Input low level UIN < 0.8 V-
Input high levelUIN > 2.4 V-
Input high current @ 5 V UIN< 1.8 mA-
Propagation delay< 1 µsec-
Sampling rateMaximum 20 kHz per channel (software selectable)
Overvoltage protection40 V continuous (65 V peak)
Isolation voltage peak250 V channel/ground & channel/channel
Digital outputs
Input channels (isolated)-816
Compatibility-Open collector with 10 kR pull-up to +5 V
Maximum sink current-150 mA (not protected)
Maximum switching voltage-50 V
Propagation delay-< 20 µsec
Maximum update rate-Depending on EtherCAT master
Isolation voltage peak-250 V channel to ground, no channel to channel isolation
General specs
InterfaceLEMO 1B EtherCAT cable (single cable connection power + sync + data)-
Data rate100 Mbit bus speed-
Power supply voltage6 to 50 V DC-
Power consumption2 Watt (all types)-
Dimensions200x50x30 mm-
WeightTypically 600 g-
Environmental ratingIP67-
Shock & Vibration Rating> 100 g-
Temperature range-40 ... 85 deg. C-
Supported Software & Hardware PlatformsSoftware: DEWESoftX2
Hardware: Krypton modules synchronise with all DEWESoft hardware
-

Contact
A-KAST Today

Call 416-667-0918 or Request a Quote